NMH410 Issue : iTunes server keeps stopping

Upgrade the firmware to 2.17.13. If you have this firmware already on the device, than try reflashing the same.

What is S.M.A.R.T Test in NAS200 ?

Self-Monitoring Analysis and Reporting Technology (S.M.A.R.T.) can warn you of impending drive problems before the drive fail. Disk 1-2, LVM, RAID 1, or RAID 0, the S.M.A.R.T. status of the drive will be displayed.

Step 1 : Open the Internet Explorer and go to the Network storage's Web Based Set-up Utility
Step 2 : Once the set-up page appears, click Administration > Disk Utility and under S.M.A.R.T click Test Now to begin checking for the disk.



Step 3 : Once you click on Test Now, a loading bar with a percentage will appear on the screen. Once complete, the result will be on Disk 1 or Disk 2 field.

This can have any of the following values:

• N/A - No disk is available.
• Not Tested - No S.M.A.R.T. check has been performed on this drive
• OK - No errors were found in the last test.
• Errors - The S.M.A.R.T. check found errors on the drive. If this happens a few times, the disk should be replaced.

Step 4 : Click Save.

Firmware 1.00.10 released for WAG160N.
Firmware fixes :

1. HNAP: FW writes settings back to flash when doing HNAP Getxxx.
2. Outbound SIP call dropped in 25 seconds at sipphone.com, CBO, SIP.
3. Web administrator username should be case insensitive, CBO, username
4. HNAP SetMACFilter2: FW allows a multicast MAC address FF:0B:DC:6F:FE:01, CBO, HNAP Hnap wireless channel issue
5. HNAP SetMACFilter2: FW allows duplicated MAC addresses, CBO, HNAP
6. HNAP SetWlanRadioSettings: FW returned "ERROR_BAD_WIDTH" when setting channel bandwidth 40, CBO, HNAP
7. HNAP SetRouterSettings: FW should not check remote management port if remote management is disabled, CBO, HNAP
8. HNAP SetWanSettings: FW allows a broadcast gateway address 12.254.169.255, CBO, HNAP
9. HNAP SetWanSettings: FW accepts blank PPPoE username with non-blank password, CBO, HNAP
10. 10. DUT should be in WPA2-Mixed mode after WPA/WPA2 configuration by setup wizard, CBO, Setup Wizard

Click here to download the firmware

ISP settings for Tele2 - Norway

Encapsulation : 1483 Bridged
Multiplexing : LLC
VPI : 8
VCI : 35

ISP setting for UTV internet - UK

Following settings should be configured on the router.
Either from the Setup Page or with the Setup CD.
Encapsulation : PPPoE
Multiplexing : LLC
VPI : 0
VCI : 35

For all Linksys devices that begfin with WAG